Installation Guide

Step1:Install the wall jamb ⑤.
Keep the wall jamb ⑤ stay
vertically, and mark the
location of all three screw
holes with a pencil.
5
x1
Remove the wall jamb ⑤
and use a power drill with
a ø6x40mm drill bit to
drill the hole at each
location marked for the
wall jamb.
Insert wall anchors ③
in each hole location.
3
x6
Ø6x40mm
5
80
mm
(3.
2in)
10mm
(
0.
4i
n)
NOTE: This shower door
can be installed directly
on the ground.
If there is a threshold,
80mm(3.2 in) is the most
suitable width, 10mm
(0.4 in) on the threshold
outside the door needs
to be left when installing
the wall jamb.
8
0mm
(
3
.
2
i
n
)
10
mm
（0
.4
in
）
Place the wall jamb ⑤
onto the wall and use a
screwdriver to tighten the
screw st4x30 ④ into the
wall anchors ③ to fix the
wall jamb.
4
x3