User Manual

Joule 2.0 User Guide page 8

Joule 2.0 User Guide page 9

Chapter 1: Starting Out

2. Insert screw threw bottom of

mount.

3. Insert two zip ties through bot-

tom of mount. Apply sticky pad and

tighten zip ties to secure mount.

1. Remove screw that holds

bottom of mount and rotate 90

degrees.

Installing CycleOps Joule™ 2.0 Using Standard Mount

For handlebar orientation, change the standard mount from the preassembled stem orientation.

4. Handlebar orientation. Be sure

to check Joule 2.0 is secure in

mount before riding.

CycleOps (ANT+) Heart Rate Strap

Wearing the heart rate strap, position it above torso as pictured. The

strap should rest just beneath the pectoralis muscles of the chest. For

best results slightly moisten the electrodes where contact is made with

skin. The heart rate strap must be worn to enable the heart rate function.

It should be snug enough to stay in place during the ride.

NOTE: Joule 2.0 is compatible with any ANT+ compatible heart rate strap.

The CycleOps heart rate strap contains a user replaceable CR2032 bat-

tery; with an expected life of three years, assuming one hour of use per

day. After replacing sensor battery, Joule must be re-paired to heart rate

sensor. See Sensor section on page 39.

Chapter 1: Starting Out

Band

Front of Heart Rate Strap

Back of Heart Rate Strap

Electrodes

Battery Door