User Manual

Joule 2.0 User Guide page 6
Joule 2.0 User Guide page 7
Chapter 1: Starting Out
Compatibility
Joule 2.0 is compatible with any ANT+ compatible power meter, speed sensor, cadence sensor
or heart rate strap. For more information on ANT+ compatible devices, please visit www.thisi-
sant.com. Note: Joule 2.0 is not compatible with combination speed/cadence sensors, wired
version of PowerTap and non-ANT+ PowerTap models such as the SL 2.4.
In addition, Joule 2.0 is compatible with the following CycleOps products:
PowerTap 2.4+ Power Meter1.
PowerTap Elite+ Power Meter2.
PowerTap Pro+ Power Meter3.
PowerTap SL+ Power Meter4.
PowerTap SLC+ Power Meter5.
PowerBeam Pro Trainer*6.
200 Pro Indoor Cycle7.
300 Pro Indoor Cycle8.
400 Pro Indoor Cycle*9.
CycleOps PowerAgent Software10.
*Important: Unit must be plugged in to work with Joule.
Chapter 1: Starting Out
3. Slide Joule 2.0 forward into
mount until it snaps into place.
5. To remove Joule 2.0 , press down on
the release lever and slide Joule 2.0
back. Note: additional sticky pads may
be used if release lever is not acces-
sible due to stem length or angle.
Installing CycleOps Joule™ 2.0 Using Standard Mount
The standard mount can be installed in either stem or handlebar orientations for use on any
handlebar or stem. The mount is preassembled for the stem orientation.
1. For stem orientation insert two
zip ties through bottom of mount
and attach sticky pad. Secure to
stem.
2. Position Joule 2.0 slightly behind
mount.
4. Be sure to check Joule 2.0 is
secure in mount before riding.
Press to
release