User Manual

Joule 2.0 User Guide page 46

Joule 2.0 User Guide page 47

1. Press and release the [MODE] button until Menu mode is displayed.

2. Press [JOYSTICK] in and release to select Sensors.

3. Press [JOYSTICK] in and release to select Power Sensor.

4. Press [JOYSTICK] up/down to highlight the desired Sensor Type. For CycleOps PowerTap Plus series hubs

press [JOYSTICK] in and release to select Add PowerTap. For CycleOps Pro Series indoor cycles select Add IC

Power. For any ANT+ compatible power sensor select Add ANT+.

5. Make sure the power sensor is awake and isolated from other active sensors by 65 feet/20 meters. For Power-

Tap and IC Power sensors rotate the hub/wheel at least one revolution. For ANT+ sensors see that sensor’s user

guide for information on waking up the sensor.

6. Press the [JOYSTICK] in and release to Start Pairing. Pairing may take up to 60 seconds. Once pairing is suc-

cessful, the sensor ID will be displayed.

7. Press [JOYSTICK] up/down to highlight Name. Press [JOYSTICK] in and release to select name and change the

name of the paired power sensor.

8. For PowerTap sensors only, press [JOYSTICK] up/down to highlight the wheel circumference and press [JOY-

STICK] in and release to select wheel circumference. Press [JOYSTICK] up/down to change wheel circumference.

Press JOYSTICK in and release to save changes. For a list of common wheel circumferences see FAQ section.

Chapter 6: Sensors

Setting Up Power Sensors

Joule 2.0 is compatible with many ANT+ sensors, each having a unique code. A sensor is deﬁned

as any ANT + compatible power meter, cadence sensor, speed sensor, heart rate strap and

CycleOps resistance unit. Joule 2.0 needs to be paired to each sensor to ensure proper function-

ality. Common CycleOps power sensors include the PowerTap hub, 300 Pro and 400 Pro indoor

cycles. Once set up, sensors can be managed using PowerAgent software. Note: if you purchased

a CycleOps 200 Pro, 300 Pro, 400 Pro indoor cycle or PowerBeam trainer all available sensors have

been paired at the factory.

Setting Up Power Sensors...continued.

9. Press [JOYSTICK] up/down to highlight Auto Zero Yes or No. Press [JOYSTICK] in and release to select Auto

Zero Yes or No. Press [JOYSTICK] up/down to change Auto Zero Yes or No. Note: Auto Zero setting should

remain set to Yes in all cases except when using a Track PowerTap.

10. Press [JOYSTICK] up/down to highlight Activate Sensor.

11. Press [JOYSTICK] in and release to Activate Sensor. Note: active sensor is designated by a hash mark next to

the sensor name in the sensor list. When switching speed sensors, be sure to activate the appropriate sensor.

12. Once a sensor has been paired and activated Joule 2.0 will automatically ﬁnd the active sensor whenever it

is turned on.

Note: multiple sensors can be stored by Joule 2.0 but only one can be active per sensor category at a given time.

Chapter 6: Sensors