User Manual

Joule 3.0 User Guide page 55
Manual Calibration for CycleOps PowerBeam Pro Trainer
If you use a power meter such as the PowerTap, you can perform a manual calibration to more
accurately calibrate your CycleOps PowerBeam Pro trainer. Note: the power meter must be paired
to Joule 3.0 prior to performing the manual calibration.
The
un Show
>
Roll Down
>
Manual
>
Reset to Defaults
The
Reset to Defaults
The
un Show
Reset to Defaults
un Show
Reset to Defaults
>
Sensor ID
Sensor ID
The
un Show
>
T o
r
ue
Of
fset
OffsetOf
>
Manual Calibration
>
T o
r
ue
Of
fset
OffsetOf
>
P
Manual Calibration
P
Manual Calibration
air New Sensor
Manual Calibration
air New Sensor
Manual Calibration
>
>
>
>
Back
<
T o
<
T o
Menu
Calibration
Use up/down to
>
match ERU to powe
r
sensor number
.
T u
:
XXXXX
ERU
Po
we
r:
>
T o
ue
Of
fset
OffsetOf
>
Manual Calibration
>
T o
r
ue
Of
fset
OffsetOf
>
T o T o
XXX
T o
XXX
T o
r
XXX
r
ue
XXX
ue
>
>
>
>
Po
wer Sensor
:
Manual Calibration Manual Calibration
XXX
Manual Calibration
XXX
Manual Calibration
>
>
>
>
Back
<
T o
<
T o
Menu
Manual Calibration
1. Before entering the calibration routine, warm up the PowerBeam Pro and tires by riding the system for fi ve
minutes.
2. Press and release [MODE] until Menu mode is displayed.
3. Press [JOYSTICK] in and release to select Sensors.
4. Press [JOYSTICK] up/down to highlight RU Sensor. Press [JOYSTICK] in and release to select RU Sensor.
5. Press [JOYSTICK] up/down to highlight the active RU Sensor. Note: the active RU Sensor is indicated by a
hash mark next to the name in the RU Sensor list. Press [JOYSTICK] in and release to select the active RU Sensor.
6. Press [JOYSTICK] up/down to highlight Calibration. Press [JOYSTICK] up/down to select Calibration.
7. Press [JOYSTICK] up/down to highlight Manual Calibration. Press [JOYSTICK] in and release to select Manual
Calibration.
8. Joule 3.0 will show the measured power using the current rolling resistance calibration.
9. Pedal at a constant speed to stabilize the resistance. Target 20 mph and press [JOYSTICK] up/down to change
the calibration until the displayed power matches the measured power.
10. When the two values match, press [JOYSTICK ].
11.The unique rolling resistance calibration is now incorporated into the factory calibration. This calibration will
remain in the system until another calibration is performed. Note: The Roll Down Calibration and the Manual
Calibration adjust the same calibration values. Only the last calibration values are saved.
Chapter 6: Sensors