Instruction Manual

ManualsBrandsSARGENT ManualsSafetyWall & Frame Switch

4390 SERIES

WALL SWITCH INSTALLATION

FOR ASSISTANCE, CALL SARGENT AT 1-800-810-WIRE.

2" x 4" (Single Gang) Wall Switch Mounting

Step 1: Install a 2" x 4" (single gang) mounting box in the

area in which the wall switch is to be installed. Be sure

the screws are vertically orientated and ensure there is

adequate clearance on each side to accommodate the

adapter plate.

Step 2: Wire the wall switch to the door controller using

the Normal Open and Common contacts (See drawing on

reverse side).

Step 3: Thread the enclosed #6-32 screws through the

adapter plate and into the 2" x 4" junction box, tightening

until approximately 1/4" remains visible.

Step 4: Slide the back plate of the switch over the screws

and allow it to settle. Use the enclosed wrench to tighten

and secure wall switch plate.

Step 5: Test for activation.

4" x 4" (Double Gang) Wall Switch Mounting*

Step 1: Install a 4" x 4" (double gang) mounting box in the

area in which the wall switch is to be installed. Be sure

there is adequate clearance on each side to accommodate

the adapter plate.

Step 2: Wire the wall switch to the door controller using

the Normal Open and Common contacts (See drawing on

reverse side).

Step 3: Press the #6-32 screw inserts into the holes in the

seal plate as shown with the hex head flush to the face of

the seal plate on the side facing the wall switch.

Step 4: Thread the enclosed #6-32 screws into the adapter

plate, tightening until approximately 1/4" of the threads

remain visible.

Step 5: Thread the 4" x 4" mounting box screws through

the seal plate adapter and into the 4" x 4" junction box as

shown. Tighten.

Step 6: Slide the back plate of the switch over the #6-32

screws and allow it to settle. Use the enclosed wrench to

tighten and secure wall switch plate.

Step 7: Test for activation.

2" x 4"

Junction box

Adapter plate

#6-32 Wall switch

mounting screws

Wall switch

4" x 4"

Junction box

Adapter plate

4"-4" Junction box

mounting screws

#6-32 Wall switch

mounting screws

#6-32 Screw plastic inserts

Wall switch

* 4-1/2" Round Wall Switches cannot be mounted on 4" x 4" boxes without a special adapter plate (P/N 0022006900) available separately.

Please contact factory for details.

Summary of content (2 pages)

PAGE 1
4390 SERIES WALL SWITCH INSTALLATION FOR ASSISTANCE, CALL SARGENT AT 1-800-810-WIRE. 2" x 4" (Single Gang) Wall Switch Mounting Step 1: Install a 2" x 4" (single gang) mounting box in the area in which the wall switch is to be installed. Be sure the screws are vertically orientated and ensure there is adequate clearance on each side to accommodate the adapter plate.
PAGE 2
4390 SERIES WALL SWITCH INSTALLATION 3" x 3" Box Mounting Step 1: Install a 3" x 3" mounting box in the area in which the wall switch is to be installed. Bend upper and lower tabs inward to accommodate wall switch. Be sure there is adequate clearance on each side to accommodate the adapter plate. Bend tab inward Step 2: Wire the wall switch to the door controller using the Normal Open and Common contacts (See drawing below).