Manual

9
800-810-WIRE (9473) • www.sargentlock.com • A7455B
Profile Series Exit Device
Copyright © 2003, 2008, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved. Reproduction in whole or in part without the express written permission of Sargent Manufacturing Company is prohibited.
Mortise Installation Instructions (Continued)
Step #2 – Install Outside & Inside Trim
Outside of door
Inside of door
(2) Flat
head
wood
screws
ET Spindle
ET Control
Wire
harness
Mortise lock
Connector
Exit Chassis
Centerline for
(2) 1/4 - 20 x 2-3/8’’
flat head
machine
screws
(2) 1/4 - 20 x 2 3/8’’
Flat head
machine screws
Wire
harness
Outside of
door
Inside of
door
Cylinder
set
screw
Cylinder
Correct Incorrect
Chassis
Lever
Latchbolt
Lever arm
(4) #10 Wood
screws
or #10-24
machine
screws
Figure 1
1. Exit Chassis:
• Route “ET” harness along track cutout for wood
doors and access hole for metal doors.
• Mount exit chassis carefully. Do not pinch
harness wires
• Position exit chassis on door so that lever arm is
under rear section of mortise lock lever. Then lift
up until latchbolt is completely retracted.
• Fasten exit chassis to door using (4) #10 wood
screws or #10-24 machine screws
2. Outside Trim
• Route harness through wire cutout and out to
other side of door
• Place “ET” control onto door
• Insert (2) 1/4-20 x 2-3/8 Flat head screws
• “ET” spindle will engage into mortise lock
3. Cylinder Installation
• Insert cylinder into “ET” control. Back out the
cylinder set screw in mortise lock
• Thread cylinder clockwise into mortise lock
until the cylinder sits flush and correct in
“ET” control (see figure 1)
• Tighten cylinder set screw