User guide

Fig. 4A
Wire
cover
(2) #6 x ½” flat head security
Torx wood screws
This side down
Inside of door
Chassis
cover
(4) #8 - 32 x 5/16”
Oval head machine
screws
Mortise Installation Instructions (Continued)
3 – Chassis Cover Instructions
Secure chassis cover to chassis using
(4) #8 - 32 x 5/16” oval head machine screws.
Note: Required for 12- Fire Rated doors only.
1. Align wire cover plate with chassis side against exit chassis
cover and mark hole positions.
2. Drill (2) 3/32” dia. by 1/2” deep holes as shown.
3. Stamped side of plate goes against door.
4. Secure wire cover plate to door directly above chassis cover
(note orientation) using two (2) #6 x 1/2” flat head security
torx wood screws.
Note: Position lower edge of cover plate against the chassis
cover to ensure no wires are visible.
(2) 3/32” dia.
by 1/2” deep
holes
Inside of door
Back side of
wire cover plate
4 - Wire Cover Instructions (Wood Door Only)
10/31/12
A7809B 17
Copyright © 2012, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved. Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
Passport 1000 PG Exit Device