User Manual

Receptacle

Plug

ElectroLynx® Connector System Notes:

The system is designed to be installation friendly with

pluggable connectors from the electric hinge through

the door to the rail. The only wiring required is to the

ﬂying leads on the pigtail harness assembly on the

frame side of the electric hinge.

IMPORTANT:

The plug and receptacle connectors are designed

to mate and lock together as shown in the ﬁgure.

Plug the connectors into each other with the locking

mechanism aligned as indicated.

Do NOT force connectors on any other way

Locking mechanism

59- Electroguard™ Exit Device - ElectroLynx Wiring Notes (Consult factory for assistance if required)

1. The ElectroLynx connector system is designed to be installation friendly with pluggable connectors from the

electric hinge through the door to the rail. The rail, raceway, electric hinge, and pigtail harness connector

terminations and wire colors all match.

2. For most applications, an 8-pin electric hinge is required.

3. A 12-pin (8 & 4-pin) electric hinge is required for all three remote alarm relay (RAR) contacts or latch bolt

monitoring (LBM) or Gang.

4. If Gang is required, a connection choice should be made depending on which rail wires are unused leading to

the 8- and 4-pin door side electric hinge. When determined, cut those wires from the door side electric hinge

connector and hard wire from the raceway to the cut electric hinge wires.

5. Plug raceway connectors into ElectroLynx hinge connectors. Hard wire to corresponding pigtail harness wires

as required.

Installation Instructions (Continued)

8 1-800-810-WIRE • www.sargentlock.com • A7690E

Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.

04/15/13

Electroguard

59- Preﬁx 80 Series Exit Device