User Manual

connector
Chassis
Rail wire &
connector
Chassis
arm
Left Hand Reverse Bevel
Illustrated
Rail assembly
Cover
Push rail
Wire & connector
Inside diameter
Inside Of
Door
H. Installing 59-8900/12-59-8900 Series Mortise Lock
Exit Device
CAUTION – BEFORE STARTING:
• Check hand of door (This device is handed and not reversible)
• Door should be fitted and hung
• Verify box label for size of exit device, function and hand
Wire &
Mortise lock
body
Vertical
reverse line (of
chassis)
IMPORTANT: Surface of door where exit
device is to be applied must be flush.
Clear away any raised projections to
allow exit device to rest on flat surface
of door.
PREPARE DOOR AND MOUNT LOCK
Refer to Instruction sheet A6705
1. Feed wire and connector through the mortise opening and out the inside diameter
C
L
4
Installation Instructions (Continued)
18 1-800-810-WIRE • www.sargentlock.com • A7690E
Copyright © 2013, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved. Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
04/15/13
Electroguard
®
59- Prefix 80 Series Exit Device