User Manual

Wire & connector Inside
diameter
Inside
Of Door
Installation Notes:
1. With new applications, a raceway harness with 8 & 4-pin connectors will be pre-installed inside the door by
ASSA ABLOY door manufacturer when specified during the ordering process. Raceway harness kits are also available
for retrofit applications. (For retrofit applications, refer to retrofit instructions)
2. If door does not have a raceway harness with connectors, either consult factory for raceway retrofit kit or cut
connectors off product and hard wire, as required.
3. Wiring to pigtail harness is per facility wiring requirement.
The rail, raceway, electric hinge and pigtail connector ( - +) terminations and wire colors all match.
1. Feed wire and connector through the mortise opening and out
the inside diameter.
• Check hand of door (This exit device is handed and not reversible)
• Door should be fitted and hung
• Verify box label for size of exit device, function and hand
IMPORTANT: Surface of door where exit
device is to be applied must be flush.
Clear away any raised projections to allow
exit device to rest on flat surface of door.
A. Installing 59-8300/12-59-8300 Series Mortise Lock Exit Device
CAUTION – BEFORE STARTING:
Cover
Mortise lock body
Chassis
Wire &
connector
Wire holder
Chassis
arm
Left hand reverse
bevel illustrated
Vertical reference line
C
L
chassis
Rail wire &
connector
Rail
assembly
Push rail
4
Installation Instructions (Continued)
PREPARE DOOR AND MOUNT LOCK
Refer to Instruction sheet A6696
10 1-800-810-WIRE • www.sargentlock.com • A7690E
Copyright © 2013, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved. Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
04/15/13
Electroguard
®
59- Prefix 80 Series Exit Device