Manual

3
A7884A • 800-810-WIRE (9473) • www.sargentlock.com
Alarmed Exit Devices AL-80 Series
5/15/08 Copyright © 2008 SARGENT Manufacturing. All rights reserved.
Reproduction in whole or in part without the express written permission of SARGENT Manufacturing is prohibited.
Auto Alarm Reset
DS3 DS4 Timer Reset
Off Off 2 minutes
Off On 5 minutes
On Off 10 minutes
On On Continuous*
Turning key clockwise, the yellow PASSAGE LED will flash for 15
s
econds (default), then a quick chirp and the ARMED green LED will
flash and repeat every 30 seconds. Signal above cylinder indicates
unit is armed.
NOTE: The unit is automatically armed 15 seconds after the unit
is turned on. Field selectable settings listed at bottom of page.
When ARMED, depressing the push rail will activate the alarm and
the horn will sound and red violation LED flashes. The horn will
continue to sound for 2 minutes (default). After 2 minutes the unit will
reset on its own and the red LED will flash every 30 seconds until
rearmed using the key. Turn the key counter clockwise to deactivate
the alarm, then clockwise to rearm.
Horn chirps intermittently to indicate low battery condition.
Change battery.
To Arm Alarm
Security/Tamper Violation
Low Battery Alert
9 volt alkaline battery
Battery
LED
Alarmed Exit (AL-) Standard Operating Instructions
4
Optional Settings
5
These field selectable switches can change the following functions:
* Recommend 3267 power supply and 546 wiring harness
Request to Exit/Passage Time Delay
DS1 DS2 Timer Reset
Off Off 7 seconds
Off On 10 seconds
On Off 15 seconds
On On 20 seconds