Manual
D. Installation Notes
1. With new applications, a raceway harness with 8 and 4 pin connectors will be pre-installed inside door by
ASSA ABLOY door manufacturer when specified during the ordering process. Raceway harness kits are also
available for retrofit applications.
2. If door does not have a raceway harness with connectors, cut connectors off product, or consult factory for
raceway retrofit kit.
3. Wiring to pigtail harness is per facility wiring requirement. The rail, raceway, electric hinge and pigtail connector
terminations and wire colors all match.
Mount exit device per instruction sheet provided
To insure trouble free operation, check that the push rail can be fully depressed. On vertical rod exit
devices, check that the latch bolts do not go into hold back position until the push rail is fully depressed.
Plug rail connector into raceway connector. Then feed through 1" hole in door. Install rail mounting bracket with two screws
supplied. Install rail insert and end cap.
Plug raceway connector into electric hinge connector, then feed through door prep. Mount electric hinge to door.
Go to (A) if wiring now. Go to (B) if wiring is to be done later.
A. Wire frame side wires to wires on pigtail harness as required using connectors allowed by local
code. Plug pigtail harness connector into electric hinge connector. Feed harnesses through frame prep
and mount electric hinge.
B. Plug pigtail harness connector into electric hinge connector. Feed harnesses through frame prep and mount
electric hinge.
1
2
3
4
E. 55- 80 Series (Signal Switch) Installation and Wiring
NOTES:
1. Switch contact rating: 2A @ 30VDC
2. Wires must be protected from abrasion
3. For use with class II circuits only
4. Wiring diagram indicates push bar extended
5. The rail, raceway, electric hinge and pigtail
connector terminations and wire colors all match
Pigtail harness
with 8-pin connector
Raceway harness with
8 & 4 pin connectors.
The 4-pin connectors
are not used.
Electric Hinge
with 8-pin connectors
Note: Typical raceway location is
shown. Other locations may exist
depending on door type.
4
55- or 12-55-
80 Series Rail with
8-pin connector
1
75
6
4
3
2
8
Brown (NO), 7
Yellow (NC), 8
Blue (C), 6
55-
Switch
Connections
1
3
2
mounting
bracket
1" dia
hole
in door
screw
location
Copyright
©
SARGENT Manufacturing. All rights reserved.
Reproduction in whole or in part without the express written
permission of SARGENT Manufacturing is prohibited.
A6808C