Manual

L
EFT
HAND DOOR
R
IGHT
HAND DOOR
PULL
H
INGE SIDE
P
ULL
HINGE SIDE
S
TOP (PUSH) SIDE STOP (PUSH) SIDE
INSTALL CLOSER INTO PREPARED FRAME WITH SPRING
ADJUSTMENT AWAY FROM HINGE WITH SCREWS PROVIDED.
B
USE DATA SHEET PROVIDED AND PREPARE
MORTISE IN FRAME AND DOOR.
A
SPRING POWER
A
DJUSTING
SCREW
B
ACKCHECK
VALVE
C
LOSING
SPEED
VALVE
LATCHING
S
PEED
VALVE
+
-
INSERT ARM ROLLER INTO TRACK THRU
CUTOUT AND TEMPORARILY LET ARM
LAY ON A TRACK.
INSTALL TRACK IN DOOR AS SHOWN USING
TAMPER PROOF SECURITY SCREWS
PROVIDED.
D
C
ASSEMBLY OF ARM TO DOOR CLOSER SPINDLE
1. USING 1/8" ALLEN WRENCH, TURN LATCHING SPEED AND DOOR
CLOSING SPEED VALVES (SEE FIGURE 1) CLOCKWISE UNTIL THEY
STOP. DO NOT FORCE VALVES.
2. USING ADJUSTABLE WRENCH, ROTATE DOOR CLOSER SPINDLE
(SEE FIGURE 1) 90∞ CLOCKWISE FOR LEFT HAND DOOR AND
COUNTER CLOCKWISE FOR RIGHT HAND DOOR.
3. OPEN DOOR 50∞ APPROXIMATELY WITH THE DOOR CLOSER
SPINDLE NOW STATIONARY, MOVE THE END OF THE ARM TO
THE SPINDLE END UNTIL SQUARE HOLE IN THE ARM LINES
UP WITH THE SPINDLE END SQUARE (AS SHOWN). PUSH ARM
UP INTO POSITION ON THE SPINDLE AND SECURE WITH
SECURITY SCREW AND WASHER.
4. RETURN LATCHING AND DOOR SPEED VALVES TO NORMAL POSITION
E
M
A
I
N
A
R
M
INDEX MARK
ON SPINDLE
R.H. SHOWN
VIEW
LOOKING UP
HINGE EDGE
OF DOOR
CUTOUT AWAY
FROM HINGES
D
OOR
WIDTH
(INCHES)
30
32
36
4
0
42
44
46
48
A
PPROXIMATE
DOOR WEIGHT
(POUNDS)
110
115
130
1
50
155
165
170
180
N
UMBER OF TURNS
OF SPRING
ADJUSTING NUT
FACTORY SET
5-10 CW
14-24 CW
SPRING ADJUSTMENT
ADJUST SPRING POWER ACCORDING TO CHART. USE CHART AS GUIDE ONLY
(SHOWN WITHOUT
T
OP PLATE)
1
PAGE
3/16" HEX*
*ONLY OPEN DOOR A FEW INCHES WHILE ADJUSTING.
INSTALLATION INSTRUCTIONS
268 Security Concealed Door Closer with CSP
(Consealed Security Package)
268 NON SIZED ADJUSTABLE FROM SIZES 2 THRU 5
Copyright © 2009, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved. Reproduction
in whole or in part without the express written permission of Sargent Manufacturing Company is prohibited.
A7325B