Manual

• Use the attached template that corresponds with the type of hinge being used

• Drill and tap prepared metal door for channel and frame for jamb bracket. Fasten with

#12-24 machine screws provided

Friction adjustment on models

(1536F, 1537F, 1538F and 1539F) only

• To increase friction, insert flat bladed screw driver as shown

and turn clockwise until desired friction is attained

LEFT HAND SHOWN

Channel

Jamb bracket

• Install channel into door (spring end towards hinge)

• Secure channel with fasteners provided

• Secure jamb bracket to frame with fasteners provided

Holding tension adjustment on hold open models only

(1536H, 1537H, 1538H and 1539H)

• To increase tension insert a 3/32” Allen wrench.

Turn clockwise as shown.

Spring end

Hinge

1536, 1537, 1538, 1539 SERIES

CONCEALED OVERHEAD HOLDERS & STOPS

INSTALLATION INSTRUCTIONS

ON-HANDED. LEFT HAND SHOWN, RIGHT HAND OPPOSITE.

FOR INSTALLATION ASSISTANCE, CONTACT SARGENT AT 800-727-5477 or www.sargentlock.com

A7500D

Reproduction in whole or in part without the express written

permission of SARGENT Manufacturing is prohibited.

A7500D TEMPLATE 7487D

PAGE 1
536, 1537, 1538, 1539 SERIES CONCEALED OVERHEAD HOLDERS & STOPS INSTALLATION INSTRUCTIONS NON-HANDED. LEFT HAND SHOWN, RIGHT HAND OPPOSITE. FOR INSTALLATION ASSISTANCE, CONTACT SARGENT AT 800-727-5477 or www.sargentlock.com 1 • Use the attached template that corresponds with the type of hinge being used • Drill and tap prepared metal door for channel and frame for jamb bracket.
PAGE 2
A7500D TEMPLATE 7485D A7500D TEMPLATE 7486D 3
PAGE 3
2 A7500D TEMPLATE 7485D A7500D TEMPLATE 7486D 3
PAGE 4
1536, 1537, 1538, 1539 SERIES CONCEALED OVERHEAD HOLDERS & STOPS INSTALLATION INSTRUCTIONS NON-HANDED. LEFT HAND SHOWN, RIGHT HAND OPPOSITE. FOR INSTALLATION ASSISTANCE, CONTACT SARGENT AT 800-727-5477 or www.sargentlock.com 1 • Use the attached template that corresponds with the type of hinge being used • Drill and tap prepared metal door for channel and frame for jamb bracket.