Owner`s manual

46
Adirondack Spas®
OWNER'S MANUAL
LE MODELS OPERATIONS TROUBLE SHOOTING GUIDE
PROBLEM PROBABLE CAUSE SOLUTIONS
Spa is not
operating
• Power failure
• GFCI breaker tripped
• Main Fuse Class G
• Transformer Fuse
• Check power source
• Try resetting GFCI breaker. If
breaker continues to trip, contact
your dealer.
• Contact Dealer
• Contact Dealer
Spa is not
heating
• Dirty filters
• Temperature setting too low
• Air trapped in circulation line
• Sensor A or B not working
• Spa could be in Economy (ECN) or
sleep (SLP) mode
• Clean the filters
• Increase the set temperature
• Using a garden hose, force water
through filter cartridge opening or
loosen the bottom heater union
to allow trapped air to escape.
• Contact your dealer
• Press the TEMP then JETS
button to adjust Heat Modes. FC
is continuous, operates same as
standard mode setting
Poor or no
water flowing
through the
jets
• Dirty filters
• Inadequate water level
• Air lock
• Clean the filters
• Fill spa to 2" above filters
• Prime the pump(s) by loosening
unions on the pump(s) until air
can be heard escaping, then tighten
unions.
Spa light out • Burned out bulb
• Light not turned on
• Fuse
• Replace with new bulb
• Press the light key to desired style
and performance
• Contact your dealer
Pump(s)
turn off
unexpectedly
• Automatic 15 minute shut off
• Pump(s) may have overheated. Built in
protective overheat shut off
• Pump #2 Fuse
• Press jets button again to start
another 15 minute cycle
• Let pump sit for about 10-15
minutes. Allow pump to cool
down, keep vented areas on access
panel free from blockage.
• Contact your dealer