Owner`s manual

Adirondack Spas®

OWNER'S MANUAL

9. Place the vacuum hose down the filter cartridge openings and vacuum any water from

filter compartment.

10.Withashopvac,gotoeveryjetinthespa(includingsuctionfittings)andplacevachose

over the face of every jet and vacuum out any water left in the lines. Reverse vac hose and

force air through each jet.

11. Wipe down spa shell with a soft clean cloth.

12. Place spa cover over spa and lock into place.

13. To restart the spa, connect all hoses and close all unions. Once all the hoses, jet valve

assemblies, and pump unions are reattached, follow the normal fill-up procedures. It may be

necessary to flush the spa depending on the amount of antifreeze used.

Note: It may be necessary to lubricate o-rings and gaskets for a positive seal. Use only

Adirondack Spas® approved lubricants, contact your local dealer for more information.

Important:

If these instructions are not followed, damage due to freezing water in the plumbing lines may occur

and is not covered under manufacturer's warranty.

* Not available on the Adirondack Spas® SE Line. The two speed jet pump is used on low speed

during filtration cycles.