Owner`s manual

32
Adirondack Spas®
OWNER'S MANUAL
CONTROL PANEL FUNCTIONS - LE MODELS
MAIN CONTROL PANEL
Thepanel/topsidewillindicatetheoperationsofthehydrojetpump(s),spalight,water
temperature and will display diagnostic symbols.
Adirondack Spas® models are equipped with a main control panel located on the top collar of
thespa.Themaincontrolpanelcontrolsallofthespafunctions.Itdisplaysthespa’sstatusand
any diagnostic messages. The main control panel and digital display are illuminated by a light
from the inside of the panel.
MAIN CONTROL PANEL BUTTONS AND DIGITAL DISPLAY
The main control panel has buttons which the spa user presses to set the temperature, vary the
intensityofthelightandactivateordeactivatethehydrojetpump(s).Thecontrolpanelalsohas
adigitaldisplaythatdisplaysthespadiagnostics(i.e.:temperaturesetting,jetfunctionsorerror
messages).
Temperature Control
Thesettemperaturerangeisfrom80°F(26°C)to104°F(40°C).Thetemperatureofthespa
waterwillautomaticallybe100°F(37°C)thefirsttimethatpowerisapplied.Thisisthedefault
temperature setting programmed at the factory.
To display the set temperature of the spa, press the Warm or Cool button once.
To raise the set temperature of the spa, press the Warm button a second time. Each press of the
Warm button will continue to raise the set temperature.
To lower the set temperature of the spa, press the Cool button a second time. Each press of the
Cool button will continue to the lower set temperature.
Note: When first powered up the water temperature will not be displayed until the pump has
been running for at least two minutes.
Note: The temperature shown on the display without pressing the Warm or Cool button
reflects the temperature of the water at that particular moment.