Owner`s manual

Adirondack Spas®

OWNER'S MANUAL

Continuous Filtration Non-Circulation Pump

To set a continuous filtration, set Filter 1 to begin at a specified time as listed above. Because

you will be running the Pump 1 low speed continuously, any start time will be fine, as the start

and end time will be the same. Remember that your cost of operation will increase by operating

Pump 1 on low speed as continuous filtration.

{Example: Start time: 8am - End time: 8am = 24-Hour Circulation}

Then set the duration as listed above, advancing the duration hours to 24. The FLTR2 cycle start

time, 12 hours after the FLTR1 start time will only engage the Purge Cycle. The end time for

FLTR2 in this setting will be unavailable with 24-Hour duration.

* When Pump 1 low is operating and an ozone generator is installed, they will operate together.

*Defaultfactorysettingisonefiltercyclesettorunintheevening(assumingthetimeofdayis

properlyset).Thesecondfiltercyclecanbeenabledasneeded.

*AtthestartofeachfiltercyclePump2(ifoneispresent)willrunbrieflytopurgeitsplumbing

to maintain water quality.