Owner`s manual

27
Adirondack Spas®
OWNER'S MANUAL
FLIP Button
Pressing the panel button marked FLIP will invert the display on the panel, allowing you to read
the display from inside or outside of the spa.
OPERATING THE HYDRO PUMP(S)/JET BUTTON(S)
Activatethehydrojetpump(s)formaximumhydrotherapyjetaction.Pressthe“Jets1”button
once for low speed, twice for high speed and a third time to turn the pump off. If your spa has
two hydro jet pumps, “Jets1” will be a two speed pump, and “Jets2” will be a single speed pump.
Pressing “Jets2” once will turn the pump on high speed, pressing “Jet2” button again will turn
the pump off.
If either pump is left running, they will turn off automatically in 15 minutes if on High speed or
30 minutes if on Low Speed.
Also, note, if your spa is in READY MODE, pump 1 low speed may turn on for at least 1
minuteevery30minutestodetectthespatemperature(polling)andthentoheattotheset
temperature if needed. When low speed turns on automatically, it cannot be deactivated from
thepanel;however,thehighspeedmaybestartedbypressingthe“Jets1”button.
Clean-Up Cycle
When “Jets1” is manually turned on, a “Clean-Up Cycle” begins 30 minutes, on low speed,
after “Jets1” is turned off. If your spa is equipped with an Ozone Generator, it will operate with
“Jets1” on low speed.
Light Button - Saratoga Lighting System
The spa light is controlled using the LIGHT button. Press the LIGHT button once to turn on
the multiple color options and locations, then again to turn the lighting off. The LIGHT button
isalsousedinconjunctionwithtemperature(s)tonavigatethesystemmenus.
Optional Splash™ Lighting
If your spa is equipped with Splash™ Lighting systems, see the operational features and
directions located in the Splash™ box, or contact your dealer for instructions.