Owner`s manual
26
Adirondack Spas®
OWNER'S MANUAL
If a Temperature button is pressed and held when the temperature is flashing, the temperature
will continue to change.
When the spa is first powered up the water temperature will not be displayed until the pump has
been running for at least two minutes. The Default Water Temp from the factory will be 80*F in
HIGH RANGE.
The temperature shown on the display without pressing the Warm or Cool button reflects the
temperature of the water at that particular moment.
HOLD Mode
“Hold Mode” is used to disable the pumps during service functions like cleaning or replacing the
filter. Press TEMP to desired hold temperature, Press LIGHT repeatedly to HOLD, then Press
TEMP to count down. The clock will count down from 60 minutes.
LOCK and UNLOCK Mode
Lockingthepanelpreventsthespafrombeingused;italsopreventsunwantedtemperature
adjustments. All automatic functions are still active. Locking the temperature allows Jets and
other feature to be used, but the Set Temperature and other programmed settings cannot be
adjusted. Temperature Lock allows access to a reduced selection of menu items, which include
Set Temperature, FLIP, LOCK, UTIL, INFO and FALT LOG.
To engage LOCK MODE, Press TEMP, Press LIGHT repeatedly until LOCK appears, then
Press TEMP. To continue, Press LIGHT to toggle TEMP or PANL, Press TEMP to toggle ON
or OFF, then Press LIGHT to exit menu.
Note: ToUnlock(UNLK)theabovefeatures,PressTEMP,thenLOCKappearson
display, Press and hold TEMP while pressing LIGHT twice. UNLK screen appears, and
then will exit to main screen in approximately 3 seconds.
SETTING 24 HOUR CLOCK
This action changes a 12 hour clock to a 24 hour clock.
Press TEMP to initiate a flashing display. When the temperature is flashing, press LIGHT
repeatedly until PREF appears on the screen. When PREF appears, Press TEMP until F/C
appears. When F/C appears press LIGHT. When "24 and 12" hour appear, you then will press
TEMP to toggle between the two to select your choice.
Then Press LIGHT to:
1) enter choice.
2) again to exit PREF menu
3) again to exit UTL menu and return to main menu
TEMPERATURE F/C DISPLAY
Provides an option to choose between Fahrenheit and Celsius
To choose between Fahrenheit and Celsius, toggle between F and C in PREF menu. Press
TEMP, then Press LIGHT repeatedly until PREF appears, Press TEMP to toggle F/C choice,
Press LIGHT twice to exit to main menu.