Owner`s manual

25
Adirondack Spas®
OWNER'S MANUAL
EQUIPMENT MAINTENANCE
Replacing the Spa’s Light Bulb
Thespa’slightbulbislocatedinsidetheequipmentcompartment.Removethefrontaccess
panel, by first removing the screws on the access panel. Then locate the light housing mounted
to the spa shell. Grasp the bulb holder on the back of the light niche. Turn bulb holder counter
clockwise to release it from the light niche. Pull bulb out of receptacle and replace it with a new
light bulb, available at your Adirondack Spas® dealer. Re-attach the light bulb holder to the
light niche by turning the light bulb holder clockwise.
CONTROL PANEL FUNCTIONS - SE MODELS
MAIN CONTROL PANEL
Adirondack Spas® models are equipped with a main control panel located on the top collar of
the spa. The main control panel controls all of the spa functions.
Thepanel/topsidewillindicatetheoperationsofthehydrojetpump(s),spalight,andwater
temperatureandwilldisplaythespa’sstatusregardingdiagnostics,remindersandsystem
functions.
MAIN CONTROL PANEL NAVIGATION
Themaincontrolpanelincludesnavigation,settingfunctionsandmodes(timeofday,
temperature,filtercycles,lightandpreferences)activateordeactivatethehydrojetpump(s),
sensor related messages, reminder messages and diagnostic messages as well as much more.
Important - Please Read
Navigating the entire menu can be accomplished with the TEMP and the LIGHT buttons.
From this point on, the “WARM” and “COOL” will be referred to as TEMP button. TEMP
buttonsare“action”buttons(changingtemperature,flashingscreenforfurtherprompts,
changingpreferenceswithinamenu).TheLIGHTbuttonisa“choose”button(LEDLightson
andoff,entersmenuswhennumbersareflashing,scrollsthroughthemenu,makesaselection).
Waiting for 10 seconds will return the panel to normal operation and a display of spa status.
Dual Temperature Control
This SE system incorporates Dual Temperature Range settings with independent set
temperatures.YourspausesaHIGHRANGE(80*F–104*F)oraLOWRANGE(55*F–
99*F)temperatureadjustment.TheHIGHRANGEwouldbeprimarilyforareadytousemode
of your spa, while the LOW RANGE can be utilized for a vacation mode or during non-use
periods.
HIGH RANGE is indicated on the display as RANGE , the LOW RANGE .
Temperature Adjustment
PressTEMPbuttons(marked“Warm”or“Cold”)fordesiredsettemperature.Thenumbersflash
duringthetemperatureadjustment.PressLIGHTtoreturntomainmenu;or,themainscreen
will return in 5 seconds. If the panel has only one TEMP button, the first TEMP button press
causes the temperature to flash, the second TEMP press causes the temperature to change, then
pressing LIGHT or waiting five seconds will return you to the main menu.