User Manual

10
Note:
΍
After 20 seconds have elapsed, the display
returns to the home screen without saving.
Ύ
Some noise may occur when power is
turned on, so it is possible to turn down
the audio input level of devices connected
to the receiver accordingly.
Ύ
Manually setting the receiver channel:
Use the + or – button to display the channel
menu on the receiver.
Long press the SET button to select the menu.
Use the + or – button to select the desired
channel and confirm it by short pressing the SET
button.
4. Matching the receiver and transmitter
channel:
΍
Infrared transmission is used to transfer the
frequency set on the receiver to a transmitter.
For the TX9S
• Turn on the transmitter and receiver.
• Use the + or – button to display the “Match
with TX” menu on receiver.
• Use the + or – button to display the "Match
with RX" menu on transmitter.
• Long press the SET button to select the menu
and then short press it to confirm.
• Place the infrared transmitter port on the
receiver near the infrared detector on the
transmitter.
• If "Sync Finished" is displayed on the
OLED screen, the frequency for use on the
transmitter is set.
• After matching successfully, press the SET
button on the receiver to return to the previous
menu.