Instruction Manual

FIRING YOUR PISTOL
***Warning ***
Never load a cartridge into the chamber until you are ready to fire the
pistol.
Do not disengage the trigger block safety until the pistol is pointed in a safe
direction and you are ready to fire.
If a cartridge does not fire and the trigger has been pulled and the trigger
block safety is disengaged, Stop! Then do the following: a) Make sure the
gun is pointed in a safe direction b) Engage the trigger block safety c) Wait 60
seconds d) Follow the instructions above for unloading the pistol.
If during firing the sound of any cartridge is noticeably softer or louder than
the previous cartridge fired, Stop! Then do the following: a) Make sure the
gun is pointed in a safe direction b) Engage the trigger block safety c) Follow
the instructions above for unloading the pistol and d) With the pistol unloaded
visually inspect the pistol for barrel blockage or damage. Then inspect the
receiver of the pistol for damage before continuing.
READ, UNDERSTAND AND FOLLOW ALL WARNINGS AND INSTRTIONS
IN THIS MANUAL BEFORE FIRING THE PISTOL.
TO FIRE THE PISTOL:
1) Make sure the pistol is pointed in a safe direction with the trigger block
safety engaged. See Fig 22
2) Make sure you are wearing eye and ear protection.
3) Keep your fingers away from the trigger. See Fig 22
4) Push the trigger block safety to the "off'' or "fire" position with the red dot
showing. See Fig 23
5) Squeeze the trigger. The pistol will fire when you pull or squeeze the
trigger with the required force. See Fig 24