Instruction Manual

Extreme caution must be used when lowering the
hammer as the manual safety and automatic firing
pin block are "off" safety when this is being done ! If
done incorrectly the pistol may FIRE.
Your pistol has a resting position or notch on the
hammer .This notch is not to be used as a half cock
position. This notch sole purpose is an additional
notch on the hammer so as to allow the sear a
chance to engage the hammer if the trigger is not
pulled fully to the rear. See Fig 34
In order to lower the hammer, first move the safety to
the “off” or “fire” position. Grasp the hammer very
firmly and put a finger between the hammer and the
firing pin. See Fig 4
Then pull the trigger and slowly let the hammer
move forward past the resting position. See Fig 5
RELEASE THE TRIGGER. Gently let the hammer
down against the rear of the slide. See Fig 6
PUSH THE MANUAL SAFETY LEVER TO THE
"ON" OR "SAFE" POSITION.
Slide Stop:
Locks the slide back when engaged located on left
hand side of the gun. See Fig 7
Magazine Release:
Locks or holds the magazine in place and is
depressed to release the magazine. See Fig 8
Rear Sight:
Drift adjustable, unless the gun is shipped with the
optional windage / elevation adjustable sight.
See Fig 9
Trigger:
A curved trigger is a single action / double action trigger and fires the gun in
single action or double action mode. See Fig 10
(Single Action / Double Action Trigger)