Instruction Manual

Do not touch the trigger while moving the safety. When operating the safety,
make sure you move it to the full extent of its travel in the desired direction,
either fully "on" or fully "off." Half-safe or partially-safe is UNSAFE.
The pistol does not incorporate a magazine disconnect safety, so the pistol
may be fired with the magazine removed from the pistol.
The pistol is designed to and will FIRE when the trigger is pulled and the
safety mechanism is in the "off" or "fire" position.
Always keep your fingers off the trigger and
outside of the trigger guard until you are ready to
pull the trigger and fire the pistol.
The pistol is designed to and will FIRE when the
trigger is pulled and the safety mechanism is in the
"off" or ''fire" position.
Always keep the muzzle pointed in a safe direction! See Fig 3
Hammer:
Located on the rear of the pistol and used to supply energy to the firing pin to
ignite the cartridge primer. See Fig 34
Lowering The Hammer:
Make sure the pistol is unloaded (see Unloading
Instructions) and pointed in a safe direction!
Your Safety Does:
Lock the sear so the trigger can not be moved rearward.By blocking the
trigger movement the hammer is also blocked from movement. If the
hammer is back and the safety is on, you can move the slide to safely
check the chamber.
Firing Pin Block:
The pistol also incorporates an automatic, internal firing pin block which stops
the firing pin from traveling forward. The firing pin block is released only by
pulling the trigger all the way to the rear as is done in firing the pistol.
See Fig 35