and the operation of your firearm at: European American Armory Corp. 1426 King Street, Cocoa, FL 32922. Phone: (321) 639-4842.
(Mechanical Malfunctions) STOP SHOOTING IMMEDIATELY AND UNLOAD YOUR FIREARM if your firearm develops: a mechanical malfunction; binding or stoppage; spitting powder/gas; a punctured cartridge primer; a bulged or ruptured cartridge case; or a sound on firing does not sound quite right. Do NOT try one more shot but unload your firearm and take it and the ammunition to a qualified gunsmith or send the firearm back to European American Armory Corp. for examination.
Do not touch the trigger while moving the safety. When operating the safety, make sure you move it to the full extent of its travel in the desired direction, either fully "on" or fully "off." Half-safe or partially-safe is UNSAFE. The pistol does not incorporate a magazine disconnect safety, so the pistol may be fired with the magazine removed from the pistol. The pistol is designed to and will FIRE when the trigger is pulled and the safety mechanism is in the "off" or "fire" position.
Extreme caution must be used when lowering the hammer as the manual safety and automatic firing pin block are "off" safety when this is being done ! If done incorrectly the pistol may FIRE. Your pistol has a resting position or notch on the hammer .This notch is not to be used as a half cock position. This notch sole purpose is an additional notch on the hammer so as to allow the sear a chance to engage the hammer if the trigger is not pulled fully to the rear.
LOADING AND UNLOADING YOUR PISTOL Make sure the pistol is pointed in a safe direction and the trigger block safety is engaged at all times while loading and unloading. NEVER allow your fingers or other objects to contact the trigger while loading or unloading. Do not disengage the trigger block safety until you are ready to fire and have the gun pointed safely downrange. TO LOAD THE MAGAZINE: 1) Press the magazine release button and remove the magazine from the pistol.
YOUR PISTOL IS NOW LOADED AND READY TO FIRE, IF THE SAFETY IS MOVED TO THE “OFF” or “FIRE” POSITION AND THE TRIGGER IS PULLED THE GUN WILL FIRE ..... TO UNLOAD: Make Sure the Safety is in the "ON" or “SAFE” position and the gun is pointed in a safe direction...... 1) Press the magazine release button and remove the magazine from the pistol. See Fig 17 The pistol does not incorporate a magazine disconnect safety, so the pistol may be fired with the magazine removed from the pistol .....
FIRING YOUR PISTOL ***Warning *** Never load a cartridge into the chamber until you are ready to fire the pistol. Do not disengage the trigger block safety until the pistol is pointed in a safe direction and you are ready to fire.
6) The pistol will fire one shot with every squeeze of the trigger, until the magazine is empty. 7) When the magazine is empty, the slide will stay open. You may remove the magazine and reload the magazine while the slide is locked open by the slide stop. See Fig 25 8) Insert the loaded magazine into the pistol. You may either press down on the slide stop or pull slightly back on the slide and release it. The slide will close and reload the chamber. The pistol will then be ready to FIRE.
4) Remove the slide stop-takedown lever by pushing on the end sticking out of the right side of the pistol and pull on the lever with your other hand. See Fig 29A and 29B 5) Slide the Barrel / Slide Assembly forward and off the receiver. See Fig 30 6) Hold the slide upside down. Retract the recoil spring and guide and remove the recoil spring and guide as an assembly. See Fig 31 7) Remove the barrel from the slide.
European American Armory Corp. 1426 King Street Cocoa, FL 32922 European American Armory Corp.
69 18 15 24 2 16 50 49 48 25 3 60 13 61 61 17 14 5 64 47 39 45 46 62 43 42 6 7 4 20 55 57 19 22 21 9 37 38 35 10 36 41 8 53 1 52 40 33 12 26 11 27 54 31 30 58 65 28 34 23 29 32 51 44 63 56 55
European American Armory Corp.
