User's Manual

STR 2000 Series Transceiver Installation Manual
Sapling, Inc. 1633 Republic Road Huntingdon Valley, PA 19006 Phone: [phone] Fax: [phone] www.Sapling-Inc.com
1. Find a location that will allow the Transceiver to transmit the signal in
open space. (hallway recommended)
2. Run the wiring through the knockouts and connect according to the wir-
ing information.
3. Tighten all four (4) screws (6-32) on the front panel.
4. Line up the Transceiver in the desired mounting location and mark the
holes.
5. Mount anchors (not included) to where the holes were marked at in the
previous step.
6. Mount the Transceiver using four (4) screws (not included).
INSTRUCTIONS
Mounting Diagram
Page 2