User's Manual

SAL-2 Series Wireless Clock Installation Manual (V1)
Sapling, Inc. 1633 Republic Road Huntingdon Valley, PA 19006 Phone: [phone] Fax: [phone] www.Sapling-Inc.com
Page 8
Installation Option #4
This option allows the user to use multiple transmitters on a campus-like environment.
If a situation arises where the need is to have multiple buildings be synchronized with the wire-
less system, there are two options.
Option 4a
There is one transmitter and the clocks or repeaters send the signal to the other buildings.
This option is when the transmitter or the clocks are in range to the repeater in the other build-
ings. If the transmitter reaches the repeaters or clocks in the other building(s), the clocks will
correct off of the repeater’s transmission of the signal.
Option 4b
There is a transmitter in each building.
Operational Instructions
Installation Option #3
There is at least one (1) high powered transceiver in the building in order to cover the entire prem-
ises. The power (24V or 110V) operated clocks are used as transceivers/repeaters.
Clock Operational Overview (Power Operation 24V or 110V Version)
The clock enables its receiver for ten (10) minutes upon power up and during normal opera-
tion every minute. The clock also has the capability to transmit every minute during normal
operation or during power up once data is received.
We highly recommend installing the main transceiver before the installation of the SAL
Series clocks. The transceiver should be located in a central location preferably in a hallway
so that there are a minimum number of walls between the transceiver and the clock. After the
installation of the transceiver, begin installing the clocks nearest to the transceiver; continue
installing remaining clocks working from the transceiver as the central point. In order to in-
stall the clock, simply connect power to the clock using our pigtail connector.