Installation Manual

15 16
17 18
19
The Sapling Company, Inc.
670 Louis Drive
Warminster, PA 18974
USA
P. (+1) 215.322.6063
F. (+1) 215.322.8498
www.sapling-inc.com
Flag Mount Installation
16) Use the M3/5-15x12 screws to attach the display
board to the housing.
NOTE: For 2.5” Digit clocks, the holes for the
screws will be on the left and right inner surfaces of
the housing. For 4.0” Digit Clocks, the holes will be
on the top and bottom surfaces.
15) Attach the power wires to the ports as
shown below.
24VAC/DC (Orange)
24VAC/DC (Yellow)
110/230VAC (Black)
110/230VAC (White)
1
2
3
4
5
Ground (Green)
17) Use the 6-32x12 screws to attach the display
board to the housing.
NOTE: For 2.5” Digit clocks, the holes for the
screws will be on the left and right inner surfaces of
the housing. For 4.0” Digit Clocks, the holes will be
on the top and bottom surfaces.
18) Remove the plastic cover from the display board.