User's Manual

VS-600 Resident Unit Manual C-1
C. Installation
This section describes how to install and wire the Resident Unit, Dome Light, and Wired Pull
Cord Station. It also explains how to enable the Pendant and Wireless Pull Cord Station for
operation. Before installing the Resident Unit, the Dome Light and Wired Pull Cord station must
first be installed and connected to the rear of the unit
C.1 Installing Dome Lights
Dome Lights are wall-mounted either above or beside room doorways. The Dome Light
measures 4.5” high by 2.75” wide by 1.5” deep. It is mounted to a backbox using the provided
two 6-32 x 1” Pan Head Phillips machine screws. The recommended backbox is a Steel City
CWLE-3/4 or equivalent.
The connections from the Dome Light to the Resident Unit are shown in the diagram below.
Dome Lights are powered by the T3-PSU-4 Power Supply Unit (see Powering Dome Lights,
section C.2).