User`s manual

Compliance Certification Services Inc.
Report No：T11112830801-LV
National Differences
Clause Requirement − Test Result – Remark Verdict
Page 42 of 72
For CLASS II EQUIPMENT the socket outlet
shall be in accordance with Standard Sheet
DKA 1-4a.
2.2.4 In Norway, for requirements see 1.7.2.1,
6.1.2.1 and 6.1.2.2 of this annex.
No TNV.
N
2.3.2 In Finland, Norway and Sweden there are
additional requirements for the insulation.
See 6.1.2.1 and 6.1.2.2 of this annex.
No TNV.
N
2.3.4 In Norway, for requirements see 1.7.2.1,
6.1.2.1 and 6.1.2.2 of this annex.
No TNV.
N
2.6.3.3 In the United Kingdom, the current rating of
the circuit shall be taken as 13 A, not 16 A.
Class III equipment.
N
2.7.1 In the United Kingdom, to protect against
excessive currents and short-circuits in the
PRIMARY CIRCUIT of DIRECT PLUG-IN
EQUIPMENT, tests according to 5.3 shall be
conducted, using an external protective
device rated 30 A or 32 A. If these tests fail,
suitable protective devices shall be included
as integral parts of the DIRECT PLUG-IN
EQUIPMENT, so that the requirements of 5.3
are met.
Class III equipment.
N
2.10.5.13 In Finland, Norway and Sweden, there are
additional requirements for the insulation, see
6.1.2.1 and 6.1.2.2 of this annex.
No TNV.
N
3.2.1.1 In Switzerland, supply cords of equipment
having a RATED CURRENT not exceeding
10 A shall be provided with a plug complying
with SEV 1011 or IEC 60884-1 and one of the
following dimension sheets:
SEV 6532-2.1991 Plug Type 15 3P+N+PE
250/400 V, 10 A
SEV 6533-2.1991 Plug Type 11 L+N
250 V, 10 A
SEV 6534-2.1991 Plug Type 12 L+N+PE
250 V, 10 A
In general, EN 60309 applies for plugs for
currents exceeding 10 A. However, a 16 A
plug and socket-outlet system is being
introduced in Switzerland, the plugs of which
are according to the following dimension
sheets, published in February 1998:
SEV 5932-2.1998 Plug Type 25 3L+N+PE
230/400 V, 16 A
SEV 5933-2.1998 Plug Type 21 L+N
250 V, 16 A
SEV 5934-2.1998 Plug Type 23 L+N+PE
250 V, 16 A
N
3.2.1.1 In Denmark, supply cords of single-phase
equipment having a rated current not
exceeding13 A shall be provided with a plug
according to the Heavy Current Regulations,
Section 107-2-D1.
CLASS I EQUIPMENT provided with socket-
outlets with earth contacts or which are
intended to be used in locations where
N