User`s manual

Compliance Certification Services Inc.
Report No：T11112830801-LV
IEC/EN 60950-1
Clause Requirement - Test Result - Remark Verdict
Page 14 of 72
3.3.1 Wiring terminals N
3.3.2 Connection of non-detachable power supply
cords
N
3.3.3 Screw terminals N
3.3.4 Conductor sizes to be connected N
Rated current (A), type and nominal thread
diameter (mm)
N
3.3.5 Wiring terminal sizes N
Rated current (A), type and nominal thread
diameter (mm)
N
3.3.6 Wiring terminals design N
3.3.7 Grouping of wiring terminals N
3.3.8 Standard wire N
3.4 Disconnection from the mains supply
Class III equipment, not connect to the mains supply.
N
3.4.1 General requirement N
3.4.2 Disconnect devices N
3.4.3 Permanently connected equipment N
3.4.4 Parts which remain energized N
3.4.5 Switches in flexible cords N
3.4.6 Single-phase equipment N
3.4.7 Three-phase equipment N
3.4.8 Switches as disconnect devices N
3.4.9 Plugs as disconnect devices N
3.4.10 Interconnected equipment N
3.4.11 Multiple power source N
3.5 Interconnection of equipment
P
3.5.1 General requirements See below. P
3.5.2 Types of interconnection circuits SELV circuit. P
3.5.3 ELV circuits as interconnection circuits No ELV interconnections. N
3.5.4 Data ports for additional equipment (see appended table 2.5) P
4 Physical requirements
P
4.1 Stability See below N
Mass of the equipment exceeding 7 kg………: Mass of equipment: 0.21 kg N
Angle of 10
°
N
Test force (N) Equipment is not a floorstanding unit. N
4.2 Mechanical strength
P
4.2.1 General See below.
P
4.2.2 Steady force test, 10N Class III equipment. N