User`s manual
IEC/EN 60950-1
Clause
Requirement - Test
Result - Remark
Verdict
1.7
Marking and instructions
P
1.7.1
Power rating and identification markings
See below
P
1.7.1.1
Power rating markings
P
Multiple mains supply connections
Not connect to the mains supply.
N
Rated voltage(s) or voltage range(s) (V)
Optional, (not connect to the mains
supply)
P
Symbol for nature of supply for d.c. only.
Optional, IEC 60417, Symbol No. 5031
used. (not connect to the mains supply)
N
Rated frequency or rated frequency range (Hz)
(not connect to the mains supply)
N
Rated current (mA or A)
Optional, (not connect to the mains
supply).
P
1.7.1.2
Identification markings
See below.
P
Manufacturer’s name or Trade-mark or
identification mark
Trade-mark : ETOP SAPIDO
P
Model identification or type reference
BR485d RB-1830
P
Symbol for Class II equipment only
Class III equipment.
N
Other markings and symbols
Additional symbols or markings do not
cause misunderstanding.
P
Certification marks
CE marking.
P
1.7.2
Safety instructions and marking
See below.
P
1.7.2.1
General
The user’s manual contains information
for operation, installation and technical.
P
1.7.2.2
Disconnect devices
Class III equipment.
N
1.7.2.3
Overcurrent protective device
No such part.
N
1.7.2.4
IT power distribution system
Class III equipment.
N
1.7.2.5
Operator access with a tool
No operator access with a tool.
N
1.7.2.6
Ozone
No such part.
N
1.7.3
Short duty cycles
Unit is designed for continuous operation.
N
1.7.4
Supply voltage adjustment
Class III equipment.
N
Methods and means of adjustment reference
to installation instructions
N
1.7.5
Power outlets on the equipment
No outlet.
N
1.7.6
Fuse identification (marking, special fusing
characteristics, cross-reference)
N
1.7.7
Wiring terminals
See below
N
1.7.7.1
Protective earthing and bonding terminals
Class III equipment.
N
1.7.7.2
Terminal for a.c. mains supply conductors
Class III equipment.
N
1.7.7.3
Terminal for d.c. mains supply conductors
Class III equipment.
N
1.7.8
Controls and indicators
See below
P
1.7.8.1
Identification, location and marking
The marking and identification of the
power switch is located that indication of
function is clearly.
P
1.7.8.2
Colours
No safety involved controls or indicators.
However LED indicators are used to
indicated the working mode of the
equipment
N
Compliance Certification Services Inc.
Page 6 of 72
Report No T11112830801-LV