User`s manual

Report No.：T11112830801-RT-1
Page 19 of 48
This report shall not be reproduced except in full, without the written approval of Compliance Certification Services.
RF output power at the lowest power level of the TPC range
For devices using TPC, the RF output power during a transmission burst when configured
to operate at the lowest stated power level of the TPC range shall not exceed the levels
given in table 2.
Table 2: Mean EIRP limits for RF output power at the lowest power level of the TPC
range
Frequency Range Mean EIRP Limit
5250 MHz to 5350 MHz 17 dBm
5470 MHz to 5725 MHz 24 dBm (see note)
NOTE : For Slave devices without a Radar Interference Detection function the mean EIRP shall be less
than 17 dBm.
The limits in table 2 do not apply for devices without TPC or when operating on channels
whose nominal bandwidth falls completely within the band 5150 MHz to 5250 MHz.
TEST EQUIPMENT
Name of Equipment Manufacturer Model Serial Number
Calibration
Due
Power Meter Anritsu ML2487A 6K00003888 N.C.R
Power Sensor Anritsu MA2491A 33265 MAY 30, 2012
Spectrum Analyzer R&S FSEK 30 835253/002 SEP. 29, 2012
Temp./Humidity
Chamber
K.SON THS-M1 242 MAY 30.2012
Remark: Each piece of equipment is scheduled for calibration once a year.