User`s manual

Report No.：T11112830801-RT-1
Page 11 of 48
This report shall not be reproduced except in full, without the written approval of Compliance Certification Services.
EUT OPERATING CONDITION
RF Setup
1. Set up all computers like the setup diagram.
2. Reset equipment and burn in the test program “MP_Test”.
3. The “Realtek Test Program for “RTL819x ” software was used for testing
The EUT driver software installed in the host support equipment during testing was
Realtek Test Program for RTL819x Drive
(1)TX Mode:
Ö IC Type: RTL_8192D
Ö Mode:5G/SingleMac
Ö Dev:WLAN0
Ö Test Item :Continuous TX
Ö TX POWER: follow “Power Control”
Ö Antenna: A Mode A, HT20、HT40 Mode AB
Ö Tx Data : 6Mbps (IEEE 802.11a mode , TX)
13Mbps (IEEE 802.11n HT20 mode ,chain 0, chain B TX)
27Mbps (IEEE 802.11n HT40 mode, chain 0, chain B TX)
Ö Bandwith: A、HT20 20MHz, HT40 40MHz
Ö Start
Target Power: IEEE 802.11a Channel Low (5180MHz) = 40
IEEE 802.11a Channel High (5240MHz) = 40
Target Power: IEEE 802.11n HT20 Channel Low (5180MHz) = 40 (Chain 0)
IEEE 802.11 n HT20 Channel High (5240MHz) = 40 (Chain 0)
IEEE 802.11n HT20 Channel Low (5180MHz) = 40 (Chain 1)
IEEE 802.11 n HT20 Channel High (5240MHz) = 40 (Chain 1)
Target Power: IEEE 802.11n HT40 Channel Low (5190MHz) = 40 (Chain 0)
IEEE 802.11n HT40 Channel High (5230MHz) = 40 (Chain 0)
IEEE 802.11 n HT40 Channel Low (5190MHz) = 40 (Chain 1)
IEEE 802.11 n HT40 Channel High (5230MHz) = 40 (Chain 1)
(2) RX Mode：
Test Item packets RX
Start RX
(3) Normal Link Setup
1. Set up all computers like the setup diagram.
2. All of the function are under run.
3. Notebook PC (2) ping 192.168.0.10 –t to Notebook PC (1).
4. Notebook PC (1) ping 192.168.0.20 –t to Notebook PC (2).
5. Notebook PC (1) ping 192.168.0.50 –t to Wireless Access Point (3).
Start test.