User manual

http://www.sapido.com.tw/ User Manual v1.0.0
5
1 Getting to know the Switch
1.1 Introduction
The Fast Ethernet Switch is equipped with 5 100Mbps copper ports and each port
provides a max speed of 200Mbps and a Full-Duplex, Collision Free Bandwidth. It’s a
multi-speed, versatile network device that combines Fast Ethernet, and Ethernet ports
in a single device. This device meets RoHS compliance. It saves power with Green
Ethernet technology.
1.2 Key Features
 Supports Auto-Negotiation on each TP port
 Supports 2047byte maximum packet length
 Supports Green Ethernet
 Link-On and Cable Length Power Saving： The switch provides detection of
cable length and adjustment of power required for the detected cable length.
This feature provides high performance with minimum power consumption
 Link-Down Power Saving：The switch implements link-down power saving on
a per-port basis, greatly cutting power consumption when the network cable is
disconnected greatly cutting power consumption when the network cable is
disconnected
 IEEE 802.3az Energy Efficient Ethernet (EEE) supported： Energy Efficient
Ethernet (EEE) ability for 100Base-TX in full duplex operation, and supports
10Base-Te for 10Base-T in full/half duplex, which can reduce power
consumption during periods of low link utilization
 Provides Store-and-Forward switching scheme
 Supports Auto-MDI/MDI-X function
 Supports IEEE 802.3x Flow-Control for Full-Duplex operation
 Back-Pressure function supports for Half-Duplex operation
 2K-entry lookup MAC address table
 Loop detection：If a loop is detected, the switch will drive the external LEDs and
buzzer alarm
 Supports QoS（Quality of Service）function