User manual

http://www.sapido.com.tw/ User Manual v1.0.0

strengthen over WEP. On WPA -PSK/WPA2-PSK, uses

encrypted key called pre-shared key, and set up common

encryption key for access point and wireless LAN handset

like WEP. There are "AES" and "TKIP" as encryption

scheme. "TKIP" automatically updates the key at regular

intervals, check and approve the communication, so it can

communicate safer than WEP key which uses single

encryption key for long time. "AES" is harder to decode

comparing to "TKIP", so it can say tougher encryption

scheme than "TKIP"

WPA-Mixed

Support WPA and WPA2 at the same time

802.1x Authentication

Radius

For radius server authentication

Personal (Pre-Shared

Key)

* If you configure Pre-Shared Key as "Hexadecimal in 64

digits", please select "Hex (64 characters) ".

* If you configure enc ryption key in "8 to 63 letters in

half-width alphabets and numbers", please select

"Passphrase

6.4.4 Access Control

Access Control allows user to block or allow wireless clients to access this router. Users

can select the access control mode, then add a new MAC address with a simple

comment and click on “Apply Change” to save the new addition. To delete a MAC

address, select its corresponding checkbox under the Select column and click on “Delete

Selected” button.

6.4.5 WPS

This page allows user to change the setting for WPS (Wi-Fi Protected Setup). Using this

feature could let your wireless client atomically synchronize it’s setting and connect to the

Access Point in a minute without any hassle. SAPIDO BRD70N could support both Self-PIN

or PBC modes, or use the WPS button (at real panel) to easy enable the WPS function.

PIN model, in which a PIN has to be taken either from a sticker label or from the web

interface of the WPS device. This PIN will then be entered in the AP or client WPS device to

connect.

PBC model, in which the user simply has to push a button, either an actual or a virtual one,

on both WPS devices to connect.

BRD70n WPS only support no encryption and WPA2

Please follow instructions below to enable the WPS function.

1. Setup Wireless LAN with WPS PIN :