Troubleshooting guide

6.
Download your installation files, and uncompress and extract all the installation images to
your local drive.
Installing Replication Components
Review the procedures for installing the replication components.
Install all replication components on the same host where a DB2 UDB data server has already
been installed and is running with both the primary and replicate databases. This simplifies the
quick-start process.
Installing Replication Server
Install Replication Server using the setup program.
Prerequisites
• Allocate a disk partition of at least 20MB for each Replication Server you are installing.
You can add more partitions later, if necessary. Check each partition to make sure it is
available and has write permissions.
• Allocate the entire partition to the Replication Server. If you allocate only a portion of the
partition to Replication Server, you cannot use the remainder for any other purpose.
Task
1.
Verify that the drive on which you install the Replication Server has enough disk space for
the components being installed, and at least 100MB of extra disk space for the installation
program.
2.
Download and extract the Replication Server installation image from the SAP
®
Service
Marketplace (SMP).
3.
Start the installation.
• On Windows, launch the setup program.
If the installer does not start automatically, double-click setup.exe or select Start >
Run and enter the following:
setup.exe
If there is not enough disk space in the temporary disk space directory, set the
environment variable TMP to directory_name before running it again, where
directory_name is the full path to and name of the temporary directory to which the
installation program writes the temporary installation files.
• (UNIX or Linux) If you downloaded the product, go to the directory where you
extracted the installation image and start the installer:
./setup.bin
CHAPTER 6: DB2 UDB-to-SAP HANA Database Replication Setup
82 Replication Server