Troubleshooting guide

If there is not enough disk space in the temporary disk space directory, set the
environment variable TMP to directory_name before running it again, where
directory_name is the full path to and name of the temporary directory to which the
installation program writes the temporary installation files.
• (UNIX or Linux) If you downloaded the product, go to the directory where you
extracted the installation image and start the installer:
./setup.bin
where setup.bin is the executable file name for installing Replication Server.
If there is not enough disk space in the temporary disk space directory, set the
environment variable IATEMPDIR to tmp_dir before running the installer again,
where tmp_dir is the full path to the temporary directory to which the installation
program writes the temporary installation files.
4.
In the Introduction window, click Next.
5.
Indicate where to install Replication Server:
•
To select an installation directory, click Choose, and browse for and select the
directory.
• To create a new directory, enter a new directory path.
•
To restore to the default directory, click Restore Default Folder.
If the installation directory you chose does not exist, you see:
The directory directory name does not exist. Do you want to create
it?
Click Yes.
If the installation directory you selected exists, and already contains an Replication Server
installation, you see:
Warning: You have chosen to install into an existing
directory. If you proceed with this installation,
any older versions of the products you choose to
install that are detected in this directory will be
replaced.
Click Next.
6.
Select the type of installation:
•
Typical – installs the default components. This is recommended for most users.
•
Full – installs every Replication Server component, including all the supported
language modules.
•
Custom – lets you select the components to install. Some components are
automatically installed if they are required to run your selected components.
Click Next.
7. Select the geographic location, agree to the license agreement, then click Next.
8.
On the Sybase Software Asset Management License Server window, select one of:
CHAPTER 4: Oracle-to-SAP HANA Database Replication Setup
Quick Start Guide for SAP HANA Database 27