Datasheet

WDR IPLens Dome SpecialtyDVR CS mount Pan-focusSSP SystemMonitor
CS-mount
35
67
54 3
28
15.4
24.4
11
1/4"–20UNC
1 9.5
136
127
LENS
LENS 4PIN
VIDEO
OUT
Rear panel
Flange-back adjustment lever
GND
AC24V
DC12V
+-
POWER
CONTROL
CBG
LINE
PHASE
LENS
LENS 4PIN
15.4
24.4
11
1/4"–20UNC
1 9.5
136
127
67
54 3
28
VIDEO
OUT
Rear panel
Flange-back adjustment lever
POWER
CONTROL
CBG
LINE
PHASE
67
54 3
28
15.4
24.4
11
1/4"–20UNC
1 9.5
136
127
LENS
LENS 4PIN
VIDEO
OUT
Rear panel
Flange-back adjustment lever
GND
AC24V
DC12V
+-
POWER
CONTROL
CBG
LINE
PHASE
LENS
LENS 4PIN
15.4
24.4
11
1/4"–20UNC
1 9.5
136
127
67
54 3
28
VIDEO
OUT
Rear panel
Flange-back adjustment lever
POWER
CONTROL
CBG
LINE
PHASE
High-resolution Camera
VCC-4795P E
High-resolution Camera
VCC-4790P E
Multi-spot /
Center-zone
BLC
24 V AC
12 V to
15 V DC
540
TV Lines
Electronic
shutter
Minimum
illumination
0.01 lx
DC
auto iris lens
ATW
Manual
Internal sync.
Line lock
Multi-spot /
Center-zone
BLC
220 V to
230 V AC
540
TV Lines
Electronic
shutter
Minimum
illumination
0.01 lx
DC
auto iris lens
ATW
Manual
Internal sync.
Line lock
Shown with optional lens
VCC-4790P EVCC-4795P E
(Unit: mm)(Unit: mm)
Model VCC-4795P E VCC-4790P E
Scanning system PAL standard 625 lines, 50 fields/sec.
Image sensor 1/3” (approx. 4.8 mm x 3.6 mm) interline transfer method CCD
Picture elements Total: 795(H) x 596(V), Effective: 752(H) x 582(V)
Horizontal resolution 540 TV lines (typical)
Minimum
illumination
(approx.)
50IRE 0.01 lx (F1.2, Gain High, B/ W mode) 0.45 lx (F1.2, Gain High color mode)
20IRE 0.004 lx (F1.2, Gain High, B/ W mode) 0.18 lx (F1.2, Gain High, color mode)
Video output level 1.0 V (p-p) (75 Ω, composite)
Video S/N ratio More than 50 dB (AGC OFF)
Backlight compensation ON / OFF ––– Slide SW, ON = Multi-spot photometry (64-section) / Center-zone photometry ––– (activated when auto iris lens used)
Day/Night Auto (High/Low) / Color / B/ W: External control
White-balance ATW / Manual ––– Slide SW
Gain control High / Normal ––– Slide SW
Gamma 0.45
Light control Optical auto iris lens / Electronic iris (indoor use)
Lens mount CS mount
Flange back 12.5 mm ±0.5 mm adjustment
Auto iris lens DC
Auto iris output DC: Drive coil (+, -), Brake (Damp) coil (+, -)
Lens iris level LEVEL: L to H ––– VR (side)
Electronic shutter 1/50, 1/120, 1/500, 1/1000, 1/2000, 1/4000, 1/10000 sec.
Electronic iris ON / OFF ––– Slide SW
Aperture compensation Sharp / Normal
Electronic iris range 0.6 lx to 30,000 lx (F 1.2 lens: color mode), 0.9 lx to 45,000 lx (F 1.4 lens: color mode)
Synchronizing system Internal sync. / Line lock
Sockets
Video signal VIDEO OUT ––– BNC
Auto iris lens LENS ––– 4-pin (side)
Power supply 24 V AC, GND ––– 3-pin terminal (rear) 12 V DC, NC ––– 3-pin terminal (rear) 220 V to 230 V AC, 50Hz
Operating
conditions
Operating Temperature: -10°C to 50°C [14°F to 122°F], Humidity: within 90% RH
Storage Temperature: -20°C to 70°C [-4°F to 158°F], Humidity: within 70% RH
Power requirement 24 V AC ±10%, 50 Hz or 12 V to 15 V DC 220 V to 230 V AC, 50Hz
Power consumption (approx.) 3.7 W 3.6 W
Camera mount 1/4”–20 UNC (top / bottom selectable)
Dimensions (approx.) 67(W) x 54(H) x 128(D) mm [2.6(W) x 2.1(H) x 6.0(D) in.]
Weight (approx.) 400 g [14.1 oz.] (without lens) 600 g [21.2 oz] (without lens)
NOTE: Specifications subject to change without notice
Shown with optional lens