Operation Manual

Chapter 5 Maintenance — Light source/temperature/lter indicators
182 - ENGLISH
Light source/temperature/lter indicators
When an indicator lights up
If a problem occurs inside the projector, the light source indicators <LIGHT1>/<LIGHT2>, temperature indicator
<TEMP>, or lter indicator <FILTER> will inform you by lighting or blinking in red. Check the status of the
indicators and take following measures.
Attention
f When switching off the projector to deal with problems, make sure to follow the procedure in “Switching off the projector” (x page 63).
Light source indicator <LIGHT1>
Light source indicator <LIGHT2>
Temperature indicator <TEMP>
Filter indicator <FILTER>
Light source indicators <LIGHT1>/<LIGHT2>
Indicator status
Blinking in red
(2 times)
Blinking in red
(3 times)
Status The light source does not light up, or the light source turns off while the projector is in use.
Cause ―
Solution
f Turn the <MAIN POWER> switch to <OFF> (x page 63), and turn on the power again.
Note
f If the light source indicators <LIGHT1>/<LIGHT2> are still lit or blinking after taking the measures, ask your dealer for repair.
f The light source indicator corresponding to the light source being lit will light up in green if the projector is in projection mode and there is no
indication of problem by lighting or blinking in red.