Operation Manual

Chapter 4 Settings — [NETWORK] menu
ENGLISH - 169
[Basic control] page
Click [Projector control] → [Basic control].
1
2
3
4
6
5
1 [POWER]
Turns on/off the power.
2 [SHUTTER]
Switches whether to use the shutter function (enabled (shutter:
closed)/disabled (shutter: open)).
3 [OSD]
Switches on (display)/off (hide) the on-screen display function.
4 [SYSTEM]
Switches the system method.
5 On-screen display of the projector
Displays the same items as shown on the on-screen display
of the projector. You can check or change the settings of the
menus. It is displayed even if the on-screen display function is
set to off (hide).
6 [INPUT SELECT]
Switches the input signal.
The content of display for the input selection button is different
depending on the model of the projector.
[Detail control] page
Click [Projector control] → [Detail control].
5
4
6
3
2
1
11
9
8
7
10
1 Control of the projector
The projector is controlled by clicking the buttons in the same
way as the buttons on the remote control. After control, the on-
screen display of the projector at the right of the control page is
updated.
2 [SUB MEMORY]
Switches the sub memory.
3 [SYSTEM DAYLIGHT VIEW]
Switches to system daylight view settings.
4 [FREEZE]
Temporarily pauses the image.
5 [P IN P]
Switches the P IN P setting.
6 [LEFT/RIGHT SWAP]
Switches the ip horizontal settings.
7 [WAVEFORM MONITOR]
Displays the waveform of the input signal.
8 [PROJECTION METHOD]
Switches the setting of the projection method.
9 [LENS]
Adjusts the projection lens.
10 [TEST PATTERN]
Displays the test pattern.
11 [GET OSD]
Updates the on-screen display of the projector at the right of the
control page.