Operation Manual

Chapter 4 Settings — [NETWORK] menu
166 - ENGLISH
Error information page
When [Error (Detail)] or [Warning (Detail)] is displayed in the [SELF TEST] display eld of the [Projector status]
screen, click it to display the content of the error/warning.
f The projector may go into the standby status to protect the projector depending on the contents of the error.
1
1 Self-diagnosis result display
Displays the item check results.
[OK]:
Indicates that operation is normal.
[FAILED]:
Indicates that there is a problem.
[WARNING]:
Indicates that there is a warning.
r [FAILED] items
Item Description
[MAIN CPU BUS] There is a problem with the microcomputer circuitry. Consult your dealer.
[FAN] There is a problem with the fan or the fan drive circuit. Consult your dealer.
[INTAKE AIR TEMPERATURE]
The intake air temperature is high. The projector may be used in an environment where
the temperature is high, such as near a heating appliance.
[OPTICS MODULE TEMPERATURE]
The temperature around the optics module inside the projector is high. The projector
may be used in an environment where the temperature is high, such as near a heating
appliance.
[EXHAUST AIR TEMPERATURE]
The exhaust air temperature is high. The projector may be used in an environment
where the temperature is high, such as near a heating appliance. Or the air exhaust port
may be blocked.
[LD1 TEMPERATURE] The temperature of the light source is high. The projector may be used in an
environment where the temperature is high, such as near a heating appliance.
[LD2 TEMPERATURE]
[LD1 STATUS] The light source has failed to turn on. Consult your dealer.
[LD2 STATUS]
[SHUTTER(MUTE-SHUTTER)] There is a problem with the shutter circuitry. Consult your dealer.
[INTAKE AIR TEMP.SENSOR]
There is a problem with the sensor used to detect intake temperature. Consult your
dealer.
[OPTICS MODULE TEMP.SENSOR]
There is a problem with the sensor used to detect temperature inside the projector.
Consult your dealer.
[EXHAUST AIR TEMP.SENSOR]
There is a problem with the sensor used to detect exhaust air temperature. Consult your
dealer.
[LD1 TEMP.SENSOR]
There is a problem with the temperature detection sensor of light source 1. Consult your
dealer.
[LD2 TEMP.SENSOR]
There is a problem with the temperature detection sensor of light source 2. Consult your
dealer.
[POWER CIRCUIT TEMPERATURE] The temperature around the power circuit is high. The air intake port may be blocked.
[FPGA TEMPERATURE] The temperature inside the projector is high. The air intake port may be blocked.
[LENS MOUNTER] There is a problem in the lens mounter. Consult your dealer.