Projector User Manual

55
Remote control
Thisfunctionallowsyoutochangebrightnessofthe
screen.
Normal...... Normalbrightness
Eco............ Lowerbrightnessreducesthelamp
powerconsumptionandextendsthe
lamplife.
Lamp control
Remote control
Lamp life control
The eight different remote control codes (Code 1–Code 8)
are assigned to the projector; the factory-set, initial code
(Code1)andtheothersevencodes(Code2toCode8).
The same code should set on both the projector and the
remote control. For example, operating the projector in
Code 7, the remotecontrol code alsomust beswitchedto
Code 7.
 To change the code for the projector
 SelectaremotecontrolcodeinthisSettingMenu.
 To change the code for the remote control:
 While holding down the MENU button, press the IMAGE
button the number of times corresponding to the remote
controlcodefortheprojector.See“Remote Control Code”
onpage13.
Lamp control
Selectthelampoperationwhenthetotallightingtimeofa
lampexceedstherecommendedtotalhoursofuse.
Mode 1.............. Thelampcanbeturnedonevenafter
exceedingtherecommendedtotal
hoursofuse.
Mode 2.............. Thelampcanbeturnedonevenafter
exceedingtherecommendedtotal
hoursofuse.Buttheprojectorturnsoff
automaticallyafter3minutes.
Lamp life control
Setting
Note:
•Lampmodecannotbechangedforawhileafterturning
ontheprojector.Lampneedssometimetostabilizeafter
thepoweristurnedon.Storedlampmodewillbeactive
afterthelampisstabilized.
•IfMode 2hasbeenselectedandtheprojectionlamp
exceedstherecommendedtotalhoursofuse,the
replacementiconwillbedisplayedatthetimeofpower-
on.Thentheprojectorwillturnoffafter3minutes.
 •TheLampreplacementiconwillnotappearwhenthe
DisplayfunctionissettoOff(p.48),during"Freeze"(p.27),
or"Noshow"(p.28).
Note:
•Whendifferentcodesaresetontheprojectorandontheremotecontrol,anyoperationcannotbemade.In
thatcase,switchthecodeontheremotecontroltofitthecodeontheprojector.
•Ifthebatteriesareremovedfromtheremotecontrolforalongperiodoftime,theremotecontrolcodewill
bereset.
Lamp replacement icon