Owner`s manual

Problem: –Solutions

No power –PlugthepowercordoftheprojectorintotheACoutlet.



  –SeeifthePOWERindicatorlightsred.

  –WaituntilthePOWERindicatorstopsblinkingtoturnontheprojector

again.TheprojectorcanbeturnedonafterthePOWERindicator

turnsred.Seepage18.

  –ChecktheWARNINGindicator.IftheWARNINGindicatorlightsred,

projectorcannotbeturnedon.Seepage59.

  –Checktheprojectionlamp.Seepage62.

  –UnlocktheKeylockfunctionfortheprojector.Seepage54.

The initial display is not shown. –MakesureOfforCountdown offarenotchosenatdisplay 

function.Seepage46.

The initial display is not same –MakesureUserorOffarenotchosenatLogo(select)

as the default set. function.Seepage47.

Input signal switches automatically. –MakesureInputsearchfunctionisadjustedproperly.Seepage45.

(or does not switch automatically)

When the projector is on and you –ThatistheFilterwarningicon.Seepage56.

press the input button, an icon

other than the Lamp mode icon

appears.

An icon other than Input mode or –ThatistheLampreplacementiconortheFilterwarningicon.See

Lamp mode icon appears. pages56or62.

Image is out of focus. –Adjustfocusoftheprojector.Seepage23.

  –Provideproperdistancebetweentheprojectorandtheprojection

   screen.Seepage13.

  –Checktheprojectionlenstoseeifitneedscleaning.Seepage61.

  –Movingtheprojectorfromacooltowarmplacemayresultin 

   moisturecondensationontheprojectionlens.Insuchcases,leave

   theprojectoroffandwaituntilcondensationevaporates.

Image is Left/Right reversed. –ChecktheCeiling/Rearfunction.Seepage50.



Image is Top/Bottom reversed. –ChecktheCeilingfunction.Seepage50.



Picture is not bright enough. –CheckiftheContrastorBrightnessisadjustedproperly.See

   pages34,41.

  –CheckifImage modeisselectedproperly.Seepages33,40.

  –Checkthelampcontrolfunction.Seepages25,53.

  –ChecktheLAMPREPLACEindicator.Ifitlights,theendoflamplife

   isapproaching.Replacethelampwithanewonepromptly.Seepage

   62.

Appendix

Troubleshooting

Beforecallingyourdealerorservicecenterforassistance,checktheitemsbelowonceagain.

–Makesureyouhaveproperlyconnectedtheprojectortoperipheralequipmentasdescribedonpages14-16.

–MakesureallequipmentisconnectedtoACoutletandthepoweristurnedon.

–Whentheprojectordoesnotprojectanimagefromtheconnectedcomputer,restartthecomputer.