Manualshelf

Operation Manual

ManualsBrandsSanyo ManualsVideo projector projectorPLC 8815E
21222324252627282930
USING THE PROJECTOR
TO
TURN ON THE PROJECTOR
Connect the projector to a computer using the appropriate terminals on the rear of the projector (See “CONNECTING
THE PROJECTOR” section on pages 1 O-l 4).
Connect the projector’s AC power cord into a wall outlet and turn the MAINS ON/OFF switch (located on the rear of the
projector) to the ON position. The LAMP POWER indicator will light RED, the READY indicator will light GREEN.
Press the LAMP POWER ON/OFF button on the remote control unit or on the
projector to ON. The
IAMP
POWER indicator light will dim and the cooling fans will
operate. The wait display appears on the screen and the count-down starts
I
(20-19-18-...l). The signal from the video source appears after 30 seconds.
i
1201
x
CAUTION:
--
--
.
.___.
THIS PROJECTOR USES A METAL-HALIL-
_
____
_
_....
_
~~
’
YOU HAVE TURNED IT ON, WAIT AT LEAST 5 MINUTES BEFORE TURNING I’
)E ARC LAMP. TO EXTEND THE LIFE OF THE LAMP, ONCE
T
OFF.
NOTE:
TEMPERATURE WARNING INDICATOR flashes red, the projector will automatically turn off.
Wait at least 5 minutes before turning the projector on.
If the TEMPERATURE WARNING INDICATOR continues to flash, follow the procedures below:
(1). Press LAMP POWER ON/OFF button to OFF.
(2). Check the air filter for dust accumulation.
(3). Remove dust with vacuum cleaner (See “AIR
FILTER CARE AND CLEANING” section on page 40.)
(4). Press LAMP POWER ON/OFF button to ON.
If the TEMPERATURE WARNING INDICATOR still continues to flash, call your authorized dealer or service
station.
TO TURN
OFF THE PROJECTOR
Press the LAMP POWER ON/OFF button on the remote control unit or on the
projector. The “Power off
?” appears on the screen. Press again the LAMP POWER
ON/OFF button to turn OFF the projector. The
LAMP
POWER indicator will light bright
and READY indicator will turn off. The cooling fans will operate for 1 minute after the
projector is turned off. (During this “cooling down” period, the projector cannot be
turned on.) The READY indicator will light green again and the projector may be turned
on by pressing the LAMP POWER ON/OFF button.
-
23
-