Operation Manual

CONNECTING THE PROJECTOR
CONNECTING THE COMPUTER
CONNECTING TO THE COMPUTER INPUT HDB15-PIN (VGA) TERMINALS (1 and 2)
Personal computers can be connected to the HDB15-pin (VGA) terminal on the projector.
. Connect the computer to these terminals using the VGA cable and VGA/MAC adapter (provided).
CONNECTING TO THE MONITOR OUTPUT HDB15-PIN (VGA) TERMINAL
This terminal contain the information that is viewed on the screen.
Monitor can be connected to the HDB15pin (VGA) terminal on the projector.
l Connect the monitor to this terminal using the monitor cable (not provided).
Pin No./Signal
HDl315PlN
ooooo
TERMINAL
00000
Red input
Green input
Blue input
Sense 2
Ground (Horiz. sync.)
Ground (Red)
Ground (Green)
Ground (Blue)
Pin No./Signal
9 Non Connect
10 Ground (Vet-t. sync.)
11
Sense 0
12
Sense 1
13 Horiz. sync.
14 Vert. sync.
15 Reserved
CONNECTING TO THE COMPUTER AUDIO INPUT JACKS (1 and 2)
l Connect audio outputs from your computer to these jacks using the audio cable (not provided).
CONNECTING TO THE MULTI-POLE 12-PIN (CONTROL PORT) CONNECTORS (1 and 2)
. If you wish to control the computer with projector’s remote control unit, you must connect control port (PS/2, Serial or
ADB port) on your computer to projector’s control port with cable. (three type cables provided)
n CONTROL PORT
5? 74
CONTROL PORT CABLE
REMOVAL HINT
Disconnect control port cable
with following steps.
1. Hold the portion (A) of the
connector with one hand.
1
B
2. Pull the portion (B) arrow
-I
4
direction and remove
L
connector.
% NOTE: The RxD port (5 pin on the Serial Port) is provided on control port 2 connector only. If you control the projector
by computer, you must connect control port 2 connector.
-lO-