Operation Manual

iii

REMOTE CONTROL BATTERY INSTALLATION

Remove

the battery

compartment

lid.

Slide the batteries into the

compartment.

Note: For correct polarity

and

terminal), be sure the battery

terminals are in contact with

the pins in the compartment.

USING THE REMOTE CONTROL UNIT

Replace

thie

compart-

ment lid,

Point the remote control toward the projector (Receiver window) whenever pressing

range for the remote control is about 5m and

60’

front and rear of the projector.

the buttons. Maximum operating

To insure safe operation, please observe the following precautions:

Use (2) AA, UM3 or R06 type alkaline batteries,

Change two batteries at the same time.

Do not use a new battery with a used battery.

Avoid contact with water.

Do not drop the remote control unit.

If batteries have leaked on the remote control, carefully wipe the case

clean and load new batteries.