Operation Manual

r
CONNECTING THE PROJECTOR
Your projector is equipped with various audio/video inputs and outputs including Computer HDB15pin (VGA) terminals,
Monitor HDBl5-pin (VGA) terminals and S-VHS video .
CONNECTING THE COMPUTER
CONNECTING TO THE COMPUTER INPUT HDB15-PIN (VGA) TERMINALS (1 and 2)
Personal computers can be connected to the HDBl5pin (VGA) terminal on the projector.
l Connect the computer to these terminals using the VGA cable and VGA/MAC adapter (provided).
CONNECTING TO THE MONITOR OUTPUT HDBl5-PIN (VGA) TERMINAL
This terminal contain the information that is viewed on the screen.
Monitor can be connected to the HDBl 5pin (VGA) terminal on the projector.
l Connect the monitor to this terminal using the monitor cable (not provided).
Pin NoJSignal
Red input
Green input
Blue input
Sense 2
Ground (Horiz. sync.)
Ground (Red)
Ground (Green)
Ground (Blue)
Pin NoJSignal
9 Non Connect
10 Ground (Vet?. sync.)
11
Sense 0
12
Sense 1
13 Horiz. sync.
14 Vet-t. sync.
15 Reserved
HDB15PIN
00000
TERMINAL
CONNECTING TO THE COMPUTER AUDIO INPUT JACKS (1 and 2)
. Connect audio outputs from your computer to these jacks using the audio cable (not provided).
CONNECTING TO THE MULTI-POLE 12-PIN (CONTROL PORT) CONNECTORS (1 and 2)
l If vou wish to control the computer with projector’s remote control unit, you must connect control port (PW2, Serial or
- ADB port) on your con
iputer to projector’s control port with cable. (thr
-ee type cables provided)
n CONTROL PORT
52 74
PSI2
Serial
ADB
Port
Port
Port
1
TxD
2 CLK ADB
3 DATA
a
5
% RxD
6
7
READY
6
9
GND
GND
GND
10
CONTROL PORT CABLE
REMOVAL HINT
Disconnect control port cable
with following steps.
1. Hold the portion (A) of the
connector with one hand.
1
B
2. Pull the portion (B) arrow -I
4
direction and remove
L
connector.
% NOTE: The RxD port (5 pin on the Serial Port) is provided on control port 2 connector only. If you control the projector
by computer, you must connect control port 2 connector.
-lO-